IBM s-series, Инструкция по установке и эксплуатации, Страница: 73 / 170

The following procedure shows how to add an IPv4 address and mask to a router
port.
1. At the opening CLI prompt, enter enable .
FastIron> enable
2. Enter the following command at the CLI Privileged EXEC level prompt, then
press Enter . This command erases the factory test configuration if still present:
FastIron# erase startup-config
Attention: Use the erase startup-config command only for new systems. If
you enter this command on a system you have already configured, the
command erases the configuration. If you accidentally do erase the
configuration on a configured system, enter the
write memory command to
save the running configuration to the startup-config file.
3. Access the configuration level of the CLI by entering the following command:
Privileged EXEC Level:
FastIron# configure terminal
Global CONFIG Level:
FastIron(config)#
4. Configure the IPv4 address and mask address for the interface:
FastIron(config)# int e 1/5
FastIron(config-if-e1000-1/5)# ip address 192.22.3.44 255.255.255.0
Note: You can use the syntax ip address <ip-addr>/<mask-bits> if you know
the subnet mask length. In the above example, you could enter ip
address 192.22.3.44/24.
Syntax: enable [<password>]
Syntax: configure terminal
Syntax: [no] ip address <ip-addr> <ip-mask> [secondary]
or
Syntax: [no] ip address <ip-addr>/<mask-bits> [secondary]
Use the secondary parameter if you have already configured an IP address
within the same subnet on the interface.
IPv4 devices running layer 2 software
To configure an IPv4 address to a device running Layer 2 software:
1. At the opening CLI prompt, enter enable .
FastIron> enable
2. Enter the following command at the Privileged EXEC level prompt (for example,
FastIron#
), then press Enter . This command erases the factory test
configuration if still present:
FastIron# erase startup-config
Attention: Use the
erase startup-config
command only for new systems. If
you enter this command on a system you have already configured, the
command erases the configuration. If you accidentally do erase the
configuration on a configured system, enter the
write memory command to
save the running configuration to the startup-config file.
3. Access the configuration level of the CLI by entering the following command:
Privileged EXEC Level:
FastIron# configure terminal
Chapter 4. Connecting Network Devices and Checking Connectivity
47