IBM s-series, Инструкция по установке и эксплуатации, Страница: 39 / 170

LEDs on the switch fabric module
The front panel provides status information using the LEDs listed in Table 6.
Table 6. Front panel switch fabric LED status
LED Description and Position State Meaning
Pwr Top-most LED On (Green) The module is receiving power.
Off The module is not receiving power.
Active Bottom-most LED On (Green) The module is functioning properly.
Off The module is not functioning properly.
Interface modules
This section describes the interface modules for the following:
v The B08S, in which you can install up to eight Interface modules in the slots
shown in Figure 2 on page 7.
v The B16S, n which you can install up to 16 interface modules in the slots shown
in Figure 4 on page 9.
Note: You cannot mix IPv4 and IPv6 modules together in the same chassis.
Table 7 lists the supported Interface modules for each type.
Table 7. Interface modules
Interface Module B08S B16S
IPv4 Interface Modules
24-port 10/100/1000 Mbps Ethernet RJ45 copper without POE X X
24-port 100/1000 Mbps Ethernet SFP
X X
2-port 10 Gbps Ethernet XFP X X
IPv6 Interface Modules
IPv6 24-port 10/100/1000 Mbps Ethernet RJ45 copper without POE X X
IPv6 24-port 100/1000 Mbps Ethernet SFP X X
IPv6 2-port 10 Gbps Ethernet XFP X X
Hot swap support
The B08S and B16S support Multi-Service IronWare R05.0.00a and later. Enhanced
Hot Swap is supported, meaning you can remove and replace the interface
modules without powering down the system, and without executing the
disable
module command. However, it is recommended that the modules be disabled
through the CLI before removal from the chassis.
Pwr
Act
i ve
net
0
8bs
0
14
Figure 7. B08S and B16S switch fabric module
Chapter 2. Product Overview
13