IBM s-series, Инструкция по установке и эксплуатации, Страница: 42 / 170

be used with the LAN physical layer (PHY) and support optical monitoring
capabilities. Types of Brocade-branded SFP transceivers for the 100/1000 1 GbE
(SFP) interface modules include:
v 1000BaseT SFP Copper, 1 Gbps up to 100 m over CAT5 or higher cabling,
RJ-45 connector
v 1000Base SX 850 nm SFP optic, 1 Gbps up to 550 m over multi-mode fiber, LC
connector
v
1000Base LX 1310 nm SFP optic, 1 Gbps up to 10 km over single-mode fiber,
LC connector
v 1000Base LHA 1550 nm SFP optic, 1 Gbps up to 70 km over single-mode fiber,
LC connector
The slots support the 100Base and 1000Base fiber cabling listed in “Network
interfaces” on page 17.
Support for 100Base-FX on the 100/1000 interface module
The 24-port 100/1000 fiber interface module supports the 100Base FX 1310 nm
SFP optic, 100 Mbps up to 2 km over multi-mode fiber, LC connector.
To enable support for 100BaseFX, enter the CLI command at the interface level of
the CLI. For CLI command details, see the section regarding
″
Enabling and
Disabling Support for 100BaseFX
″
in the Configuration Guide .
2-port 10-Gigabit Ethernet interface modules
The 2-port 10-Gigabit Ethernet modules contain two physical ports, through which
you can connect the IBM device to other network devices at a speed of 10 Gigabits
per second.
Only supported Brocade-branded fiber-optic transceivers can be used in this
product. The XFP-compliant fiber-optic modules provide an optical transceiver or
physical medium dependent (PMD) interface for single or multi-mode fiber that can
be used with the LAN physical layer (PHY), and support optical monitoring
capabilities. Types of Brocade-branded XFP transceivers for the 10 GbE interface
modules include:
v Short Reach, 850 nm serial pluggable XFP optic, 10 Gbps up to 300 m over
multi-mode fiber, LC connector
v Long Reach, 1310 nm serial pluggable XFP optic, 10 Gbps up to 10 km over
single-mode fiber, LC connector
v Extended Reach, 1550 nm serial pluggable XFP optic, 10 Gbps up to 40 km over
single-mode fiber, LC connector
v 10 Base CX4, XFP transceiver, 10 Gbps up to 15 km, CX connector
Figure 10 shows the IPv4 2-port 10-Gigabit Ethernet module’s front panel.
42XG
Lnk
Act Lnk
Act
1
2
net
0
8bs
0
2
0
Figure 10. IPv4 2-port 10-Gigabit Ethernet module’s front panel
16
Ethernet Switch s-series Installation and User Guide