IBM s-series, Инструкция по установке и эксплуатации, Страница: 43 / 170

The IPv6 version has an identical appearance, except for the label on the left side,
which reads 62XG.
LEDs for 2-port 10-Gigabit Ethernet module
The 10 Gbps ports provide status information using the LEDs . This chapter
highlights the meanings and appearance of the LED on the 2-port 10-Gigabit
Ethernet module.
Table 9. LED on the 2-port 10-Gigabit Ethernet module
LED Position State Meaning
Lnk Top left of connector On Fiber port is connected.
Off No fiber port connection
exists.
Act Bottom left of
connector On or Blinking The port is transmitting and
receiving traffic.
Off The port is not transmitting or
receiving traffic.
Network interfaces
Table 10 lists the network interfaces supported on the devices.
The output of the show media command displays the type of media installed in the
ports.
Table 10. Network interfaces
Interface Show Media Description
1000Base-LHA M-LHA
1000Base-LX M-LX
1000Base-SX M-SX
1000Base-T M-C
100Base-FX M-FX, M-FXB1, or M-FXB2
10GBase-CX4 XG-CX4
10GBase-ER XG-ER
10GBase-LR XG-LR
10GBase-SR XG-SR
¹ xxxx denotes the wavelength; for example, C1550.
² Supported on copper ports only.
Port regions
Ports on the devices are grouped into regions. For a few features, such as port
monitoring and unknown unicast configurations, you will need to know the region to
which a port belongs. However, for most features, a port’s region does not affect
configuration or operation of the feature. If a port’s region does affect configuration
or operation of a feature, it is noted and described in the appropriate feature section
of this guide.
v B08S and B16S management module with 2-port 10-GbE
– Port 1
Chapter 2. Product Overview
17