IBM s-series, Инструкция по установке и эксплуатации, Страница: 54 / 170

Table 13. Installation tasks for your switch and locations of more detailed
information (continued)
Task
Number Task
Where to Find More Information
8 Attach a management station to the
management module’s serial
(console) port or a 10/100/1000
Ethernet port. “Attaching a management station” on
page 37
9 Power on the AC power supplies. “Powering on the system” on page 38
10 After the chassis is powered on,
observe the LEDs or display the
status of the modules using the CLI to
determine that the chassis is
operating properly. “Verifying proper operation” on page 40
Unpacking a system
Review the list below and verify the contents. If any items are missing, contact the
place of purchase.
v B08S or B16S with the following installed:
– one or two 12-volt System (SYS) power supplies
– fan tray assembly or assemblies
– slot panels installed in all unoccupied slots
– The B08S and B16S also come with two switch fabric modules already
installed.
v Rack Mount Kit (B16S models only)
v Management module(s) (packaged separately)
v Optional interface modules (packaged separately)
v CD-ROM containing software images and the user documentation (including this
guide)
v
A 115V AC power cable for each AC power supply
Installation precautions
Follow these precautions when installing the chassis.
General precautions
Attention: Refer to the “Safety notices” on page xiii before beginning any of these
procedures.
Attention: Do not install the device in an environment where the operating
ambient temperature might exceed 40° C (104° F).
Attention: Make sure the air flow around the front, sides, and back of the device
is not restricted.
Attention: If you do not install a module in a slot, you must keep the slot panel in
place. If you run the chassis with an uncovered slot, the system will overheat.
Attention: Never leave tools inside the chassis.
28
Ethernet Switch s-series Installation and User Guide