IBM s-series, Инструкция по установке и эксплуатации, Страница: 36 / 170

B08S and B16S management modules
The management modules for the B08S and B16S are interchangeable between
devices. Standard management modules provide Layer 2 and base Layer 3
functionality only.
Note: Premium management modules support full Layer 3 functionality.
v
The IBM Ethernet Switch B08S and B16S management modules are
interchangeable with each other, and are only supported on these chassis
models.
v You cannot intermix different management modules in the same chassis. For
example, if you have an IPv4 2-port 10 GbE Management Module installed in a
chassis, you must match it with another IPv4 2-port 10 GbE Management Module
within that chassis.
v You cannot mix IPv6 and IPv4 modules in the same chassis. A chassis must
contain either all IPv4 management and IPv4 interface modules, or all IPv6
management and IPv6 interface modules.
Table 4 lists the management modules for the B08S and B16S.
Table 4. Details regarding the management modules for the B08S and B16S
Management Modules Description
IPv4 management modules
Management Module (IPv4) no ports
Management Module 10 GbE
(IPv4) two 10-GbE ports
IPv6 management modules
Management module 10 GbE
(IPv6) Contains two 10 GbE ports for network connectivity
512 MB SDRAM enables support for large routing tables (1,000,000 BGP routes)
with the full Layer 3 code.
The B08S and B16S management modules perform the following tasks:
v Control the hardware components
v
Control the separate switch fabric modules
v Run the networking protocols
v
Provide the real time operating system
B08S management modules are located in slots 9 and 10, just above the switch
module slots; see Figure 2 on page 7.
B16S management modules are located in slots 9 and 10 along the center of the
chassis; see Figure 4 on page 9.
Figure 5 on page 11 shows the front panel of the IPv4 management modules with
no ports.
10
Ethernet Switch s-series Installation and User Guide