IBM RS/6000 SP, Руководство по определению проблем

Страница: 162 / 316

This soft copy for use by IBM employees only.
The next field, Backup Primary Node, may not be present on the SMIT screen. If
recent maintenance has been applied to the system, it may be there because
this functionally was introduced with the new code for the SP Switch. If this field
is present but the High Performance Switch is installed on the system, leave this
field blank; otherwise refer to the previous chapter on the switch for
recommendations on which node to choose as the
backup primary node. If you
have an SP Switch installed but do not have this menu option, then it is essential
that the required maintenance is installed to support this new switch.
The last field refers to the partition that is being customized. This procedure
must be completed separately for each of the respective partitions.
When the OK message is displayed after Enter has been pressed, the data that
had been entered will have been placed in a file called custom. Based on the
example above, this will be in the directory:
/spdata/sys1/sypar_configs/1nsb0isb/config.8_8/layout.1/sypar.1
Here is a custom file based on this example:
sypar-name: spcws
IP-address: 9.180.60.199
primary-node: 1
default-install-image: default
PSSP-code-level: PSSP-2.1
backup-primary-node: default
Always check after the customization of the partitions that these files were
created in their respective
syspar directories and that the contents are correct.
In the example used, this is the custom file for the
default partition because it is
associated with the hostname of the Control Workstation.
5.3.5 Verify the Configuration
Always verify the configuration before attempting to apply it. This is done at the
SMIT menu Apply System Partition Configuration. Figure 66 on page 143 shows
an example of this menu:
142
SP PD Guide