IBM Magstar MP 3570 C Series, Информация по обслуживанию

Страница: 527 / 675

017 (continued)
1. “Decorative Cover—Drive-Only Models” on
page APPENDD-6.
2. “FID B2: Cooling Pack” on
page APPENDD-11.
3. “Drive Assembly Top Cover” on
page APPENDD-10.
Replace the following FRUs in the failing drive in
the order listed:
1. Drive logic card (40%) at “FID EA: Drive Logic
Card” on page APPENDD-15.
2. Drive servo card (40%) at “FID EC: Drive
Servo Card and FID E9: Mother Board” on
page APPENDD-28.
3. Mother board (10%) at “FID E9: Mother
Board” on page APPENDD-29.
4. Drive sensor cable (10%) at “FID DA: Drive
Sensor Cable” on page APPENDD-32.
When complete, go to “Verify Fix” on
page PROC-7, then go to “End of Call” on
page PROC-12.
018
(From page APPENDC-21)
You are here because your library device does not
recognize that one or more magazines are
installed.
During calibrate, the library should sense that a
magazine is present and then inventory the
cartridges that are in the magazine. It should then
mark each cartridge present or absent on the
library operator panel display. With the current
failure on the machine, the library device is not
able to sense the presence of the magazine, with
or without tape cartridges installed.
Does the machine fail to recognize both
magazines?
Yes No
019
Only one magazine is not recognized.
Inspect the failing magazine lock lever and
ensure that it is not broken, and that it is in
the locked position. If it is in the locked
position, do the following:
Perform the following remove procedures:
(Step 019 continues)
019 (continued)
1. “Library Chassis Covers” on
page APPENDD-4.
2. “FID B2: Cooling Pack” on
page APPENDD-11.
3. “Drive Assembly Top Cover” on
page APPENDD-10.
Now replace the following FRUs in the order
listed:
1. Magazine 2 sensor (left) or Magazine 1
sensor (right) (90%) at “FID A0:
Magazine 2 Sensor” on
page APPENDD-53.
2. Library sensor cable (4%) at “FID A5:
Library Sensor Cable” on
page APPENDD-54.
3. Library control card (2%) at “FID 97:
Library Control Card” on
page APPENDD-42.
4. Drive logic card (2%) at “FID EA: Drive
Logic Card” on page APPENDD-15.
5. Library interface cable (1%) at “FID A2:
Library Interface Cable” on
page APPENDD-53.
6. Mother board (1%) at “FID E9: Mother
Board” on page APPENDD-29.
When repairs are complete, go to “Verify
Fix” on page PROC-7 then go to “End of
Call” on page PROC-12.
020
Neither magazine is recognized as being installed.
Inspect the failing magazine lock levers and
ensure that they are not broken, and are in the
locked position. If they are in the locked position,
do the following:
Perform the following remove procedures:
1. “Library Chassis Covers” on
page APPENDD-4.
2. “FID B2: Cooling Pack” on
page APPENDD-11.
3. “Drive Assembly Top Cover” on
page APPENDD-10.
Replace the following FRUs in the order listed:
1. Library control card (40%) at “FID 97: Library
Control Card” on page APPENDD-42.
2. Drive logic card (40%) at “FID EA: Drive Logic
Card” on page APPENDD-15.
(Step 020 continues)
APPENDC
Appendix C
APPENDC-25