IBM IntelliStation E Pro, Руководство по техническому обслуживанию аппаратной части

Страница: 76 / 182

5. Rotate the diskette drive bay cage until the drive cage latch catches the front
of the computer chassis.
6. Remove the screws holding the diskette drive in place and slide the diskette
drive out of the rear of the bay.
7. Touch the static-protective package containing the diskette drive to any
unpainted metal surface on the computer; then, remove the diskette drive from
the package and place it on a static-protective surface.
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
9. Slide the drive into the drive bay through the rear of the drive cage, and then
attach the diskette drive to the drive cage.
10. Rotate the drive cage back into the computer chassis.
11. Connect one end of the diskette or IDE signal cable into the back of the drive
and the other end of the cable into the diskette or IDE connector on the
system board. For the location of the diskette or IDE connectors, see “System
board internal cable connectors” on page 44.
Note: Make sure to route the signal cable so that it does not block the airflow
to the rear of the drives or over the microprocessor.
12. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
13. If you have other options to install or remove, do so now.
14. Replace the cover (see “Replacing the cover of the 6226” on page 72).
15. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Replacing a hard disk drive in bay 2
To replace a hard disk drive in the IBM IntelliStation E Pro Type 6226 computer,
complete the following steps:
1. Read the information in “Preinstallation steps” on page 64.
2. Turn off the computer and attached devices, and disconnect all external cables
and power cords.
66
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual