IBM IntelliStation E Pro, Руководство по техническому обслуживанию аппаратной части

Страница: 40 / 182

3. Locate the boot block jumper (JP6) on the system board, removing any
adapters that impede access to the jumper.
Microprocessor
and fan
AGP
Internal
speaker
Rear fan
connector
PCI
connector 1
PCI
connector 2
PCI
connector 3
Battery
DIMM
connector 1
Microprocessor
fan connector
(CN3) DIMM
connector 2
Wake on LAN
connector
®
SCSI LED
connector
System fan
connector 1
(CN2)
Password
check
(JP1)
jumper
Boot block
jumper (JP6)
CMOS
clear
jumper
(JP3)
4. Move the jumper from pins 1 and 2 to pins 2 and 3.
5. Replace any adapters that were removed and replace the cover (see
“Replacing the cover of the 6216” on page 55 or “Replacing the cover of the
6226” on page 72). Reconnect the power cords for the computer and monitor
to electrical outlets.
6. Insert the flash diskette (see Note at the beginning of this procedure) into drive
A, and turn on the computer and monitor.
Note: No image will be displayed on the monitor while the flash update
diskette is running. This is normal.
7. After the update session is completed, remove the diskette from the diskette
drive, and turn off the computer and monitor.
8. Unplug all power cords from electrical outlets, and remove the cover.
9. Remove any adapters that impede access to the boot block jumper (JP6).
10. Replace the boot block jumper to pins 1 and 2.
11. Replace any adapters that were removed.
12. Replace the cover (see “Replacing the cover of the 6216” on page 55 or
“Replacing the cover of the 6226” on page 72), and reconnect all cables that
were disconnected.
13. Turn on the computer to restart the operating system.
30
IBM IntelliStation E Pro Types 6216 and 6226: Hardware Maintenance Manual