IBM IntelliStation E Pro, Руководство по техническому обслуживанию аппаратной части

Страница: 107 / 182

Beep/symptom FRU/action
3-3-3 (No operational memory in
system.)
1. Install or reseat the memory modules, and then do a 3-boot reset.
(For more information about a 3-boot reset, see “Using the
Configuration/Setup Utility program” on page 11.)
2. DIMMs.
3. System board.
No-beep symptoms
No-beep symptom FRU/action
No beep occurs during POST.
v System board
No beep, no video, and the
system attention LED (if
present) is off.
v
System board
No beep, no video, and the
system attention LED (if
supported) is on.
v See “Undetermined problems” on page 117.
BIST failed.
v Microprocessor
Diagnostic error codes
Note: In the following error codes, if XXX is 000 , 195 , or 197 , do not replace a
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
Error code/symptom FRU/action
001-XXX-000 (Failed core tests)
v System board
001-XXX-001 (Failed core tests)
v
System board
001-250-000 (Failed system board ECC)
v System board
001-250-001 (Failed system board ECC)
v System board
005-XXX-000 (Failed video test)
1. Video adapter (if installed)
2. System board
011-XXX-000 (Failed COM1 serial port test) 1.
Check loopback plug connected to externalized serial port.
2. Check cable from externalized port to system board.
3. System board.
011-XXX-001 (Failed COM2 serial port test) 1.
Check loopback plug connected to externalized serial port.
2. Check cable from externalized port to system board.
3. System board.
014-XXX-000 (Failed parallel port test)
v System board
Symptom-to-FRU index
97