If this is the initial installation for a blade server in the BladeCenter T unit, you
must configure the blade server with the blade server Setup utility and install the
blade server operating system. See the documentation that comes with the blade
server for instructions.
Removing a blade server
Complete the following steps to remove a blade server from the BladeCenter T
unit.
Note:
If you do not shut down a blade server properly, it cannot be restarted using
the Wake on LAN feature.
1.
Shut down the blade server operating system; then, press the blade server
power-control button (behind the blade server control panel door) to turn off
the blade server. Wait at least 30 seconds until the drives stop spinning, before
proceeding to the next step.
2.
Open the two release latches as shown in the illustration on page “Removing
and installing a blade server or filler module” on page 60. The blade server
moves slightly out of the bay.
3.
Pull the blade server out of the bay.
4.
Place either a filler blade or another blade server in the bay within 20 minutes.
Completing the installation
After you install modules and route and secure any power cords (if necessary, see
the
Rack Installation Instructions
for information about routing the cords), start the
BladeCenter T unit (if it is not already started) and verify that it is working
correctly.
1.
Make sure the LEDs on the modules indicate that they are operating correctly.
Make sure that:
v
The input and output power LEDs on each power module are lit, and the
fault LEDs are not lit.
v
The power LED on each management module is lit.
v
The power LED on each I/O module is lit.
2.
Make sure that the power LED on each blade server is lit, either steady or
blinking.
See “BladeCenter T unit power, controls, and indicators” on page 15 for
information about starting the BladeCenter T unit and the location of the LEDs on
the modules. See the documentation that comes with the blade server for the
location of the LEDs on the blade server.
62
BladeCenter T Type 8267: Hardware Maintenance Manual and Troubleshooting Guide
Содержание BladeCenter T
