IBM BladeCenter T, Руководство по техническому обслуживанию и ремонту, Страница: 84 / 140

AC rear panel
Captive fastener (6)
6. Remove the old ac rear panel from the system.
7. Remove the new ac rear panel from its packaging.
8.
Position the new ac rear panel so that it aligns with the power inlet
receptacles on the system. Make sure that the ac rear panel is well seated on
the system.
9. Using a screwdriver, tighten the seven captive fasteners on the new ac rear
panel. Torque the screws to 8 inch-pounds.
Note: Torque the captive fasteners to 8 inch-pounds.
10. If you have no other replacement procedures to perform at the rear of the
system, reinstall the LAN module (see “Installing the LAN module” on page
55) and the KVM module (see “Removing and installing the KVM (keyboard,
video, mouse) module” on page 53).
11.
Plug each power cord into the input power connections on the rear of the
BladeCenter T unit (see “Starting the BladeCenter T unit” on page 16).
12. Start the system (see “Starting the BladeCenter T unit” on page 16).
Upper flex circuit assembly
Complete the following steps to replace the upper flex circuit assembly.
Note:
v
Read “Installation guidelines” on page 35.
v
Read the safety notices in “Safety” on page v.
v
Read “Handling static-sensitive devices” on page 37.
1.
Shut down and remove power from the system (see “Shutting down the
BladeCenter T unit” on page 17).
2. Remove each power cord from the input power connections on the rear of the
BladeCenter T unit.
64
BladeCenter T Type 8267: Hardware Maintenance Manual and Troubleshooting Guide