IBM BladeCenter T, Руководство по техническому обслуживанию и ремонту, Страница: 48 / 140

BladeCenter T networking guidelines
Your networking administrator should assist in the configuration of the network
infrastructure before you connect the BladeCenter T unit to a LAN switch or
similar network device. This section provides additional guidelines that might be
useful in setting up your system.
A BladeCenter T unit with two Ethernet switch modules and one management
module has the internal configuration that is shown in the following illustration:
MAC
1a
1b
2a
2b
3a
3b
4a
4b
5a
5b
6a
6b
7a
7b
8a
8b
1
2
3
4
5
6
7
8
Switch A
Mgmt
Mod
Switch B
100 Mbps links
10/100 Mbps
1 Gbps or
100 Mbps links
1 Gbps links
1 Gbps links
Note: 2nd switch module is optional
Each blade server has two independent Ethernet controllers, each with its own
MAC address and a dedicated 1 Gbps link to one of the switch modules in I/O
module bays 1 and 2 (controller 1 to switch A and controller 2 to switch B in the
illustration). In this configuration (the default), the blade servers share access to
four external ports on each switch. There is no internal data path between the two
switches within the BladeCenter T unit; an external network device is required for
data packets to flow from one internal switch to the other.
The management module has a separate internal 100 Mbps link to each switch.
These links are for internal management and control only. No data packets are
allowed to flow from application programs on the blade servers to the
management module over this path. A separate, nonswitched path (not shown) is
used for communication between the management module and a service processor
on each blade server.
A typical, preferred network topology is shown in the following illustration. See
the document that comes with the management module for more information and
other topologies and guidelines.
28
BladeCenter T Type 8267: Hardware Maintenance Manual and Troubleshooting Guide