IBM BladeCenter T, Руководство по техническому обслуживанию и ремонту, Страница: 67 / 140

CM
M
1
CM
M
2
ESD
Media tray
Release latch
Removing the media tray
Complete the following steps to remove the media tray in the front of the
BladeCenter T unit:
1. Open the two release levers as shown in the illustration. The media tray moves
out of the bay approximately 0.6 cm (0.25 inch).
2. Make sure that the release latches are in the open position (90° from the closed
position).
3. Grasp the media tray at the front of each side of the module and carefully pull
the module all the way out of the bay. Set it in a safe place.
4.
Within 1 minute, install another media tray into the BladeCenter T unit.
Installing the media tray
Complete the following steps to install the media tray in the front of the
BladeCenter T unit:
1. Hold the media tray at the front of each side of the module and orient the
media tray to the top of the media-tray bay. Carefully position the module into
the rails in the media-tray bay.
2. Make sure that the release latches are in the open position (perpendicular to the
front panel of the media tray).
3.
Slide the media tray forward into the media-tray bay until it stops on the ends
of the release latches.
4. Rotate in the release latches until they lock. This fully seats the media tray into
the connectors in the media-tray bay and secures the media tray in the
BladeCenter T unit.
Chapter 4. Setting up the BladeCenter T hardware
47