IBM BladeCenter T, Руководство по техническому обслуживанию и ремонту, Страница: 97 / 140

22. Remove the new mechanical chassis from its packaging, and set it into
position to reassemble all the parts.
23.
Install the backplane insulator into the new chassis.
UP
Mechanical chassis
24.
Install the backplane on the chassis; then, insert and tighten the six
non-captive screws that mount the backplane to the chassis.
Note: Tighten the screws to 8 inch-pounds.
25. Install the rear chassis stiffener bracket (see page 12 on page 69).
26. Install the left and right docking board/blower housing assemblies (see page
15 on page 68).
27. Install the two upper flex circuit assemblies (see “Upper flex circuit assembly”
on page 64).
28. Install the two lower flex circuit assemblies (see “Lower flex circuit assembly”
on page 66).
29.
Reinstall the rear ac panel (see “Rear panel” on page 63).
30. Install the blowers at the rear of the unit (see “Installing a blower module” on
page 52).
31. Install the KVM module at the rear of the unit (see “Installing the KVM
module” on page 54).
32. Install the LAN module at the rear of the unit (see “Installing the LAN
module” on page 55).
33. Install the I/O switches at the rear of the unit.
34.
Install the media tray at the front of the unit (see “Installing the media tray”
on page 47).
35. Install the management modules at the front of the unit (see “Installing a
management module” on page 50).
36.
Install the blade servers at the front of the unit (see “Removing and installing
a blade server or filler module” on page 60).
Chapter 5. Service replaceable units
77