Hyster A1.3-1.5XNT, Руководство по обслуживанию

Страница: 68 / 124

When the wrench icon is continuously ON, it
means that scheduled maintenance is due. When it
is flashing, it indicates that an active fault has
been detected by the system. The wrench icon ap-
pears in the bottom location of the status/warning
icon area when it is displayed. It has the lowest pri-
ority of the three icons, wrench, hydraulic filter, or
hydraulic fluid level, that can be displayed in this
location.
The hydraulic filter icon shows in the same loca-
tion, in place of the wrench icon, if a hydraulic filter
restriction is detected. It has the second highest
priority of the three icons that can be displayed in
this location.
The hydraulic fluid level icon shows in the same lo-
cation, in place of the wrench icon or the hydraulic
filter icon, if a low level is detected in the hydraulic
fluid reservoir. It has the highest priority of the
three icons that can be displayed in this location.
The motor temperature high icon is displayed if a
high motor temperature is detected, meaning that
the temperature of one of the motors or motor con-
trollers has gone above the defined threshold tem-
perature.
The brake fluid low icon is displayed if a low level
is detected in the brake fluid reservoir.
The fasten seat belt icon is displayed for the first
ten seconds after the truck is powered ON, or for
ten seconds after the seat is reoccupied after the op-
erator leaves the seat for ten seconds or more. This
warning is based on seat occupancy, not the seat
belt connection itself. If the operator selects a
screen other than the Operating Screen before the
ten seconds are up, the fasten seat belt icon will no
longer be displayed.
BATTERY DISCHARGE INDICATOR
NOTE:
Because the Battery Discharge Indicator
(BDI) algorithm determines the Battery State Of
Charge (BSOC) based on information gathered dur-
ing operation it may take several seconds for the
BDI to show the correct BSOC for the battery.
The BDI is located in the top center of the Operat-
ing Screen, as shown in Figure 12. The BDI is dis-
played as a five-segment horizontal bar and it has a
battery icon on its left side.
1. BATTERY DISCHARGE INDICATOR
Figure 12. Battery Discharge Indicator
The system continuously monitors the truck's cur-
rent BSOC, and this is indicated on the BDI by the
number of filled bar segments. Table 14 shows the
battery's state of charge in percentages, compared
to the number of filled segments.
Table 14. BSOC in Relation to BDI
BSOC Charge
Remaining (%) Number of Filled Segments
76% or more Five (5)
50% to 75% Four (4)
35% to 50% Three (3)
25% to 35% Two (2)
21% to 25% One (1) segment, plus flashing
plus low battery alarm
0 to 20% Zero (0) segments, plus
flashing plus a second low
battery alarm
The BDI is always visible when the Operating
Screen is active. All five of the BDI segments are
filled (illuminated) when the BSOC is at 75% or
higher. As the BSOC goes down, the segments on
the right change to just outlines until the BSOC
reaches 25%, which is indicated when only the left-
most segment, next to the battery icon, is filled.
Operating Screen 2200 SRM 1336
62