Hyster A1.3-1.5XNT, Руководство по обслуживанию

Страница: 115 / 124

Press the 2 or 3 soft key to set the outputs that con-
trol the rear lights to Enabled or Disabled.
RESTORE DEFAULT SETTINGS
NOTE:
This submenu is available on all trucks to
logged in Service Technicians and Supervisors.
This menu allows a Service Technician or Supervi-
sor to change all adjustable truck settings back to
their factory default settings. Calibrations are NOT
reset when this function is used. Figure 69 shows
the Restore Defaults Screen.
While in this menu, press the Enter Key to restore
all truck settings, except hour meters and system
time, to their factory default settings. The system
then returns to the Truck Setup Menu.
Figure 69. Restore Defaults Screen
Diagnostics Menu
INTRODUCTION
The Diagnostics Menu is a main menu (top-level
menu) that is visible only at the Service Technician
password access level. To enter this menu, cycle
through the main menu title screens by pressing
the Scroll Back Key (
◂
—) or Scroll Forward
Key (—
▸
) until the Diagnostics Title Screen is dis-
played, as shown in Figure 70.
Figure 70. Diagnostics Title Screen
Press the Enter Key (*) to enter the Diagnostics
Menu. The system will then display the first sub-
menu in this menu, the Fault Code Log submenu,
which is shown in Figure 71. Press the Enter Key
again to enter this submenu. For a different sub-
menu, use the Scroll Back Key or Scroll For-
ward Key to move to the desired submenu and
press the Enter Key.
Figure 71. Fault Code Log Submenu
The Diagnostics Menu offers these submenus (see
the Diagnostic Submenu Icons topic in the Icon
Glossary):
• Fault Code Log
• Speedometer
• Direction Switch
• Traction Motor 1 Status
• Traction Motor 2 Status
2200 SRM 1336 Diagnostics Menu
109