HW Group Poseidon2 3266, Руководство пользователя, Страница: 82 / 104

Poseidon2
– Family manual
HW group
www.HW-group.com 82 / 104
<Entry>
<ID>152</ID>
- Entry identification
<Name>DTR</Name>
<Type>2</Type>
<Value>0</Value>
<Mode>3</Mode>
<CondInputID>75</CondInputID>
<Trigger>22.5</Trigger >
</Entry>
</BinaryOutSet>
<SenSet>
- All detected sensors
<Entry>
<ID>57856</ID>
- Entry identification, ID address of the sensor (Read only)
, source for
<
CondInputID>, ID in unique per device,
48..122 and 256..65535 are reserved for sensors
<SensId>57856</SensId>
- Full 1-Wire ID address of the sensor (Read only)
, 1-Wire ID
is unique. 1-Wire
sensors only
<Name>Sensor 240</Name>
- Defined name of the sensor (text string, 15 chars)
<Units>C</Units>
- Unit of send value "C" for temperature,
"%RH" for humidity, "V" for voltage "mA" for current
“s” for Switch (0/1) “p” for counter pulses (1/10 digit can be used)
etc...
<Value>23.0</Value>
-
Current value, one decimal value, decimal separator is “.” (Read only)
<Calib>-0.15</Calib>
- Sensors calibration shift value (Value = Raw sensor value + Calib)
Not implemented yet - ready to use in the future
<Min>-1.5</Min>
- SafeRange minimal limit
<Max>24.6</Max>
- SafeRange maximal limit
<Hyst>0.0</Hyst>
- Hysteresis (non sensitivity range) value
<SNMPTrap>1</SNMPTrap>
- SNMP trap alarm enable 0 = don't send, 1 = send if value out of SafeRange
<Email>0</Email>
- E-mail alarm enable 0 = don't send, 1 = send if value out of SafeRange
<SMS>0</SMS>
- SMS alarm enable 0 = don't send, 1 = send if value out of SafeRange
<Delay>0</ Delay> - 0..255 Time delay in seconds to prolong Alarm state reaction. (used for Alarm Start even
for Alarm End reaction)
Similar to Hysteresis but in time
<ApDelta>0</ ApDelta>
- AutoPush is a function allowing sending of measured data in case of value
increase/decrease larger than AutoPush delta parameter.
<State>0</State>
- Current sensor state
0 = normal, 1 = Alarm activated (value out of SafeRange) but not send (Alarm
sending by Email or Trap not activated),
2 = value out of SafeRange - Alarm sent, 4 = sensor invalid (not connected)
</Entry>
<Entry>
<ID>74</ID>
<Code>74</Code>
<Name>Sensor 23</Name>
<Units>C</Units>
<Value>23.8</Value>
<Calib>0.19</Calib>
<Min>10.0</Min>
<Max>60.0</Max>
<Hyst>0.0</Hyst>
<SNMPTrap>0</SNMPTrap>
<EmailSMS>0</EmailSMS>
<ApDelta>0</ ApDelta>
<State>0</State>
</Entry>
</SenSet>