Husqvarna SM 400, Руководство по ремонту

Страница: 160 / 533

D.44
Part. N. 8000 A2925 (03-2004)
REGISTRAZIONI E REGOLAZIONI
SETTINGS AND ADJUSTMENTS
RÉGLAGES ET CALAGES
EINSTELLUNGEN UND REGULIERUNGEN
AJUSTES Y REGULACIONES
BOZZA DRAFT
Adjusting the suspensions according to particular track conditions
The following information is a useful guide for setting up the suspensions
according to the road conditions.
Always start from the standard calibration before making any change on the
suspensions. Afterwards, increase or decrease the adjusting clicks one at a
time.
HARD GROUND
Fork: softer compression adjustment.
Shock absorber: softer compression adjustment.
The softer adjustment for the two suspensions is also used both in
compression and in extension when driving at top speed, in order to have
better grip of the tires.
SANDY GROUND
Fork: have a harder compression adjustment, or replace the standard spring
with a harder one, and make a softer compression adjustment and a harder
extension adjustment at the same time.
Shock absorber: have a harder compression, and expecially a harder
extension adjustment. Work on the spring preload to lower the motorcycle rear
side.
MUDDY GROUND
Fork: have a harder compression adjustment, or replace the standard spring
with a harder one.
Shock absorber: have a harder compression and extension adjustments, or
replace the standard spring with a harder one. Work on the spring preload to
lift the motorcycle rear side.
We advise replacing the springs of both suspensions to compensate the
weight increase due to the piling of the mud.
NOTE:
When the fork results as either too soft or too hard for any adjustment
conditions, check the oil level inside the forkrod.
The level can either be too low or too high. Remember that too much oil inside
the fork will involve a more frequent air drainage. When the suspensions do
not react to the changes of calibration, check that the adjusting units are not
blocked.
The standard calibrations and the adjustment procedures are shown on the
next pages. The springs available upon request, together with the preload
spacers, are shown on chapter “Optional parts list”.