Chapter 6
Replacing Parts
83
System Board (top view)
Primary Processor (CPU 1)
Secondary
Processor
(CPU 2)
System Board
Installing a Second Processor
This section provides the instructions for installing a second processor and its accompanying heatsink on the
system board.
CAUTION
The processor is sensitive to static electricity and can be easily damaged by
improper handling. Do the following when handling the accessory kit:
Leave the processor in the anti-static bag until you are ready to install it.
Wear an anti-static wrist strap and use a static-dissipating work surface or grounding
mat connected to the chassis when handling components.
Before you remove a processor from the anti-static bag, touch a grounded,
unpainted metal surface on the HP Netserver LP 1000r to discharge static
electricity.
1. Unpack the processor shipping box and check the contents against its packing list.
2. If the Netserver is already installed and operating, shut down the NOS according to directions in
your NOS documentation.
3. Press the power switch on the HP Netserver's control panel when prompted by the operating
system.
Normally, this completes the shutdown procedure.
WARNING
Power supplies will continue to provide standby current to the Netserver until the
power cables are disconnected.
