Chapter 4
Diagnostics
38
Code
Description
Problem/Solution
controller resource
conflict
between the integrated flexible disk controller and an accessory
board.
To correct this:
1. If the integrated flexible disk controller is not needed, run the
Setup Utility
and disable the flexible disk controller.
2. If the integrated flexible disk controller is needed, the
accessory board's IRQ and address space must be
reconfigured to use other free resources. Refer to the
accessory board installation manual for information.
0400
CD-ROM boot error
POST has detected the CD-ROM drive has reported an error
during its self-test.
To correct this:
1. If a CD-ROM disk is present, verify it is correctly inserted.
2. Verify the CD-ROM drive door or tray has not been opened
or closed during the self-test.
3. Verify all data cables and power cables are firmly connected.
4. If the problem persists, your CD-ROM drive may need to be
replaced. Contact your service representative to replace your
Netserver.
0401
CD-ROM drive not
responding
POST has detected the CD-ROM drive is not responding, but is
configured in the
Setup Utility
.
To correct this:
1. If the CD-ROM drive has just been removed, press
[F4]
to
automatically validate the change.
2. Verify all data cables and power cables are firmly connected.
3. If the cable is damaged, connect the hard disk drive to
another IDE cable, if available. The
Setup Utility
and the 32-
bit disk access driver may need to be modified accordingly.
4. If the problem persists, your CD-ROM drive may need to be
replaced. Contact your service representative to replace your
Netserver.
0500
Hard Disk (primary)
controller boot error
(This does not apply
to LP 1000r)
POST has detected a general failure on the integrated (primary)
hard disk controller.
To correct this:
1. Restart your HP Netserver.
2. If the error persists, your system board may need to be
replaced. Contact your service representative to replace your
Netserver.
3. If no device uses the other IDE channel, connect your hard
disk drive to the other cable to operate with the secondary
