Chapter 6
Replacing Parts
73
A
B
Replacing the Top Cover
8. Install the Netserver back into the rack and secure it to the rack.
NOTE
Some rack options do not require removing the HP Netserver from the rack to
remove or replace the top cover.
Removing the Front Bezel
The front bezel is provided to protect the power and reset switches from accidental disabling.
To remove the front bezel, follow these steps:
NOTE
You do not need to removal the front bezel to remove the top cover of the Netserver.
You do need to remove the front bezel to install mass storage devices or media.
1. If the Netserver is operating, you do not need to turn off power to remove the front bezel.
2. Release the front bezel by placing your hand at the center of the half-moon opening in center of
the front bezel.
3. Pull out towards you on the front bezel.
The bezel rotates down to approximately a 80
°
angle.
4. Pull and lift the bezel out toward you, and remove it from the chassis.
