Chapter 6
Replacing Parts
72
Removing the Top Cover
Replacing the Top Cover
To replace the top cover, follow these steps:
1. If the HP Netserver is already laying on a flat surface with no power applied, continue with Step
5.
2. If the HP Netserver was operating with the cover removed, power down the operating system
and turn off the Netserver power switch.
3. Disconnect the power cord and any cables attached to the Netserver.
4. Remove the Netserver chassis from the rack and lay it on a flat surface.
5. Ensure the knob is turned to the "Open" position (clockwise position).
6. Place the rear edge of the top cover on the rear edge of the chassis and lay it down on the
chassis.
7. Rotate the knob to the "Closed" position (counter clockwise position).
