Chapter 1
General Information
2
CD-ROM
Flexible Disk Drive
(FDD)
RE S E T
CD-ROM Eject Button
FDD Activity LED
CD-ROM Activity LED
FDD Eject Button
SCSI Disk ID 0
SCSI Disk ID 1
SCSI Disk ID 2
Input and Storage Device Controls
Table 1-1. Power Switch and
Control/Indicator
Description
Power On/Off/Sleep
Switch
Push-button
Switch
This push-button turns the HP Netserver power On or Off, and if available, also
transitions the Netserver between Power On and sleep states. If sleep states are
not available, then this button only turns power On or Off.
The sleep states are NOS dependent and not available if your NOS does not
support power management based on the ACPI (Advanced Configuration and
Power Management Interface) standard. Refer to "Applying Power to the HP
Netserver" and "Sleep States (ACPI)" later in this chapter.
On/Off/Sleep LED
LED
This green LED indicator provides the power state of the Netserver:
•
•
•
•
Steady Green
when the Netserver is operating normally
•
•
•
•
Blinking Green
at 1-Hz rate indicates the Netserver is in a sleep state and
under ACPI control.
•
•
•
•
Off
(unlit)when the Netserver is powered off or in standby
Reset Switch
RESET
Reset
Switch
This push-button momentary switch creates a hard system reset, when pressed.
This is equivalent to a power-on reset.
Table 1-2. Component Indicators
LED ICON
Description
Temperature
LED
This Temperature LED has two distinctive colors:
•
•
•
•
Steady Green
for normal operation
•
•
•
•
Steady Red
indicating the temperature has exceeded the critical threshold
Fan LED
This Fan LED and its sensor monitors the fan speed of all fans in the HP
Netserver and has two distinctive colors:
•
•
•
•
Steady Green
for normal fan speed operation
