Chapter 4
Diagnostics
39
Code
Description
Problem/Solution
controller. Verify the secondary IDE controller is enabled in
Setup.
4. If the IDE device operates with the secondary channel, your
system board may need to be replaced to recover primary
channel functionality. Contact your service representative to
replace your Netserver.
5. If the device does not operate on either channel, the IDE
device may be defective. Contact your service representative
to replace your Netserver.
0501
Hard Disk secondary
controller boot error
(This does not apply
to LP 1000r)
POST has detected a general failure on the integrated
secondary hard disk controller.
1. If no device uses the other IDE channel, connect your hard
disk drive to the other cable to operate with the primary
controller. Verify the primary IDE controller is enabled in
Setup.
2. If the IDE device operates with the primary channel, your
system board may need to be replaced to recover secondary
channel functionality. Contact your service representative to
replace your Netserver.
3. If the device does not operate on either channel, the IDE
device may be defective. Contact your service
representative.
0510
Hard Disk boot Error
Error codes #0510,
#0511, #0512, and
#0513 apply to IDE0,
IDE 1, IDE 2, and IDE
3 respectively as
described in the
Setup Utility
).
(This does not apply
to LP 1000r)
POST has detected the specified hard disk drive reported an
error during its self-test.
To correct this:
1. Check the hard disk drive configuration with the
Setup
Utility
.
2. If necessary, edit the user hard disk parameters to set lower
values.
3. If the problem persists, your drive may need to be replaced.
Contact your service representative.
0520
Hard Drive not
responding
(Error codes #0520,
#0521, #0522, and
#0523 apply to
HDD0, HDD1, HDD2,
and HDD3
respectively as
described in the
Setup Utility
).
(This does not apply
to LP 1000r)
POST has detected the specified hard disk drive is not
responding, but is configured in the
Setup Utility
.
To correct this:
1. If the specified hard disk has just been removed, press
[F4]
to automatically validate the change.
2. Verify all data cables and power cables are firmly connected.
3. If the cable is damaged, connect the hard disk drive to
another IDE cable, if available.
4. If the problem persists, your hard disk drive may need to be
replaced. Contact your service representative.