Chapter 6
Replacing Parts
81
9. Remove a DIMM from its container, handling the module by its edges.
If not ready to install it, lay it on an anti-static surface until you are ready.
CAUTION
Use only HP PC133 (133 MHz) buffered SDRAM DIMMs.
10. Align the notches on the DIMM with the keys on the slot.
Retaining Latches (2)
DIMM Slot
Keys
Notches
DIMM to Slot Alignment
WARNING
Ensure you hold the DIMM tightly as you push it into the slot. It is possible to turn or
bend the DIMM slightly while inserting it, which would damage or break the DIMM
socket.
If a DIMM socket is damaged, you must use another DIMM slot or replace the entire
HP Netserver, since this Netserver is not repairable in the field.
11. Holding the DIMM at approximately 30
°
to the system board, press the DIMM fully into the slot
until the retaining latches close.
If the latches do not close, the DIMM is not inserted correctly.
NOTE
The system board is shown removed from the Netserver for clarity.