Chapter 4
Diagnostics
32
Message
Corrective Action
If no message
appears
(screen is
blank)
•
If no text or messages appear listen for the beep codes. Refer to Beep Codes
in Table 4-3.
•
If no message appears but the Netserver stops after POST, verify the DIMMs
are correctly installed.
If a
configuration
error occurs
If a Netserver configuration error is reported during the startup routine, clear the
CMOS memory as described under "Clearing the CMOS Configuration," and restart
the Netserver.
System CMOS
checksum bad
•
Press
[F2]
to run Setup.
•
Change settings as required.
•
Choose the Exit option, selecting Save Changes and Exit to save the new
settings.
The Netserver should reboot.
Power-On Self Test (POST) Error Codes
These error codes (POST codes) appear in normal video if an error condition occurs during the boot process
of the HP Netserver LP 1000r. All the codes and the respective descriptions are listed in the
HP Netserver
LP 1000r Service Manual
, but not all the codes apply to this Netserver. The service manual is also located
on the
HP Netserver Online Documentation CD-ROM
provided with the HP Netserver.
These codes will appear on the display monitor, provided it and the supporting circuitry are functioning:
NOTE
Do not take remove/replacement actions until you have taken other troubleshooting
steps. See the troubleshooting checklist.