•
WWide Node Name (FC drive only) — world wide unique number for the drive. The library
assigns WWNames to the drive bays. When a tape drive is replaced, the WWName is
re-assigned to the replacement drive.
•
Port information for each configured port (FC drive only)
WWide Port Name — world wide unique identifier for the port. The WW Node and Port
Name will be slightly different.
◦
◦
Port Type — the current setting of the drive port. Direct connected devices are typically
Loop. Devices connected to a switch are typically Fabric.
◦
Speed
Viewing network information
The
Identity > Network page
displays information about the network configuration.
Figure 35 Identity > Network page
You can see, but not modify:
•
MAC Address — a unique identifier for the library controller network interface
•
Full Qualified Domain Name — the fully qualified domain name for the device
•
Clock Synchronization Configuration (SNTP) — When Enabled, the device will obtain the
current time and date from the configured SNTP server.
When IPv4 Addressing is Enabled, you can see, but not modify:
•
IPv4 DNS Server 1 and IPv4 DNS Server 2 — addresses of the configured DNS servers
used when DHCP Addressing is not Enabled.
•
DHCPv4 Addressing — When Enabled, the device will request an IP address from a DHCP
server each time the device is booted.
Using the RMI
59