Use
Set Date and Time
to set the date and time used to record events. Access to this feature
requires the administrator password.
To set the date:
1.
From the Home screen, press
Previous
or
Next
until the screen displays
Configuration
.
Press
Enter
to select.
2.
Press
Previous
or
Next
until the screen displays
Library Date/Time
. Press
Enter
to select.
3.
Enter the administrator password if prompted.
4.
The screen displays
Set Yr/Month/Day 2012 / 07 / 21
with a flashing number. Press
Previous
or
Next
to change the value of the flashing number. Press
Enter
to accept the value of the
flashing number and move to the next number.
5.
Repeat Step 4 until all numbers in the date are correct. Press
Enter
.
6.
The screen displays (example)
Set Hour / Mins 16 : 52
with the first number flashing. Press
Previous
or
Next
until the flashing number reads correctly. Press
Enter
to move to the next
number. Repeat this step until all numbers in the time are correct. Press
Enter
.
Configuring network settings (Configuration > Configure Network Settings)
The device can automatically obtain an IP address from a DHCP server when the device is
powered on. The device also supports user-specified fixed addresses through the front panel.
The device also supports SNMP. You can enable SNMP and configure the target addresses with
the RMI. See
“Changing the network configuration” (page 73)
.
To configure IPv4 network settings:
1.
From the Home screen, press
Previous
or
Next
until the screen displays
Configuration
.
Press
Enter
to select.
2.
Press
Previous
or
Next
until the screen displays
Configure Network Settings
. Press
Enter
to select.
3.
Press
Previous
or
Next
until the screen displays
IPv4 Networking Enabled
. Press
Enter
to select.
4.
Press
Previous
or
Next
until the screen displays
DHCP Enabled
. To change the setting,
press
Enter
. Press
Next
until the screen shows the desired setting. Press
Enter
to accept
the new setting.
5.
If DHCP is disabled, press
Previous
or
Next
until the screen displays
IP Address
. The
second line displays the current IP address.
6.
To change the IP address, press
Enter
. The screen displays
Set IP Address
with the first
number flashing. Press
Previous
or
Next
to change the flashing number to the correct value.
7.
Press
Enter
to select the next number, until all numbers have been set. The screen displays
New IP Address.
8.
Press
Previous
or
Next
until the screen displays
Subnet Mask Address
. To change the
Subnet Mask Address
, press
Enter
. The screen displays
Set Subnet Mask Address,
with
the first number flashing.
9.
Press
Previous
or
Next
to change the flashing number to the correct value. Press
Enter
to
select the next number.
10. Repeat Step 9 until all numbers have been set. The screen displays
New Subnet Address.
11. Press
Previous
or
Next
until the screen displays
Gateway Address
. To change the
Gateway
Address
, press
Enter
. The screen displays
Set Gateway Addr,
with the first number flashing.
12. Press
Previous
or
Next
to change the flashing number to the correct value. Press
Enter
to
select the next number.
13. Repeat Step 12 until all numbers have been set. The screen displays
New Gateway Addr.
Press
Enter
.
To enable IPv6:
1.
From the Home screen, press
Previous
or
Next
until the screen displays
Configuration
.
Press
Enter
to select.
Using the MSL2024 OCP
101