HP HP 8753E, Руководство пользователя, Страница: 257 / 699

Entering the Power Sensor Calibration Data
Entering the power sensor calibration data compensates for the frequency response of the
power sensor, thus ensuring the accuracy of power meter calibration.
1. Make sure that your analyzer and power meter are configured. Refer to the “Compatible
Peripherals” chapter for configuration procedures.
3.
4.
5.
6.
7.
The analyzer shows the notation EMPTY, if you have not entered any segment information.
To create the segment, press:
Enter the frequency of a correction factor data point, as listed on the power sensor,
followed by the appropriate key:
. . . .
.... . ..
. . . . . . . .
you have entered in the previous step. Complete the correction factor entry by pressing (xl)
Repeat the previous two steps to enter up to 55 frequency segments
You may enter multiple segments in any order because the analyzer automatically sorts
them and lists them on the display by frequency value. The analyzer also automatically
interpolates the values between correction factor data points
If you only enter one frequency segment, the analyzer assumes that the single value is valid
over the entire frequency range of the correction.
After you have entered all the frequency segments, press
Editing Frequency Segments
. . . . . . . . . . . . . . . . . . .
that you want to edit).
Identify the segment that you want to edit by pressing and using the and
.
keys to locate and position the segment next to the pointer shown on the display. Or
. . . .
. . . . . . . . . . . . . . .
press and enter the segment number followed by (xl).
. . . . .
. .
. . . . . .
. .
part of the segment you want to edit.
q
If you are modifying the frequency, enter the new value, followed by a or
key.
q
If you are modifying the correction factor, enter the new value, followed by the (xl) key.
. .. . . . . . . . . .
If you want to edit any other segments, press and follow the previous steps,
.
starting with step 2.
Optimizing Measurement Results 535