Hospira GemStar Series, Руководство по эксплуатации системы

Страница: 70 / 221

Hospira GemStar System Operating Manual 61
Chapter 4. Pain Management
Pain Management Programming
1
Select
PAIN MANAGEMENT
from the Programming Menu.
2
Select the delivery mode.
3
Select the unit of measure and concentration as required.
4
Set the continuous delivery rate.
5
Program a loading dose as required.
6
Program a bolus dose with lockout time and dose limit as required.
Regarding a 1-Hour or 4-Hour Dose Limit: The hour dose limit is the
maximum volume (continuous plus bolus or bolus only amount) that can be
delivered over the selected period. When the programmed dose limit is reached,
the continuous delivery stops and a new bolus is not allowed. As the oldest
delivery amounts age out of the 1-hour or 4-hour dose limit record, the pump
accepts bolus requests or resumes continuous delivery (if programmed).
7
If programmed in units of mcg or mg, the line displaying the units flashes. Enter
the container size in proper unit measure.
8
Select the air sensitivity, if required.
9
Review the program. Press to begin review.
10
If using the PURGE key to prime the pump set, press [
PURGE
] now.
d
Note: If Cont Bolus is selected, the continuous delivery rate or bolus dose
can be set to zero without reprogramming the pump. Press [
STOP
] and press
[
CHANGE
] , then select
CHANGE PROGRAM
.
d
Note: If a 1-hour or 4-hour dose limit is programmed, a bolus in progress will stop
when the amount infused reaches the dose limit.
Loading doses are included in a 1-hour or 4-hour dose limit. A dose limit in effect
could prevent the delivery of a loading dose.
d Note: To enter the total in mL when programming a concentration, press to
move to the mL line. Enter the mL value when
mL
flashes on the display.
WARNING: ALWAYS disconnect the pump set from the patient before
priming or purging.