ID61/62 Series Panel - Installation, Commissioning & Configuration Manual
Installation Guide
14
997-457-000-8, Issue 8
January 2010
2.5.4 Flush Mounting Bezel (Optional)
If flush mounting of the ID61/62 Series Panel is required,
a recess 110mm deep for the ID61 back box, or 208mm,
for the ID62 back box, and just large enough to
accommodate the back box must be cut in the wall (refer
to
Section 2.5.3 Back Box Fixing
for dimensions).
To fit the bezel:
1
Before continuing, remove panel electronics and
batteries (if fitted) - see
Section 2.5, Dismantling the
Panel
.
2
Offer the bezel (A), flat sideways towards you, to the
front of the back box (B) and position it so the bezel
front face (C) is lined up with the front face of the
back box shoulder (D).
3
With the bezel held in position, use the slotted holes
(E) on the bezel side plates as guides to drill eight
3mm holes. Remove any swarf created.
4
Secure the bezel using M3 self-tapping screws.
Note:
The ID61/62 Series Panel back box must be fixed
to a solid vertical surface, or sub-frame inside the
recess, using its rear fixing holes. DO NOT rely
on the bezel as a means of fixing.
5
Fit the back box with attached bezel to the wall recess
and re-assemble the panel, see
Section 2.6
Assembling the Panel
.
Before drilling the back
box, make sure that no
equipment is fitted.
All dimensions in millimetres
