Honeywell HX3, Руководство пользователя, Страница: 84 / 230

5 - 44
Password
Start > Settings > Control Panel > Password
Use this panel to set HX3 user access to control panels and power up password properties.
Important: This password must be entered before performing a cold boot or cold reset.
If entering a power-on or screen saver password does not allow you to disable this password protection or perform a cold
boot, contact Customer Support.
The password and password settings are saved during a warm boot and a cold boot. The screen saver password affects
the Remote Desktop screen saver only. After a password is assigned and saved, each time a
Settings > Control Panel
option is selected, the user will be required to enter the password before the Control Panel will open. The screen saver
password is the same as the power-on password. They are not set independently. A screen saver password cannot be
created without first enabling the “Enable password protection at power-on” check box. The screen saver password is not
automatically enabled when the “power-on” check box is enabled.
1. Enter the password in the Password text box, then press Tab and type the password again to confirm it.
2. Enable the power-on check box and, if desired, the screen saver check box.
3. A changed/saved password is in effect immediately.
Setting Default
Password Blank
Enter password at Power On Disabled
Enter password at Remote Desktop Screen
Saver Disabled