402
compress-port
Description
Sets rules for compress or non-compress at the L4 port number DPORT (Destination
PORT) of a SYN packet on the LAN side of a session subject to WAN acceleration
processing.TCP header and what comes after that are to be compressed.
For the initial setting, compression or non-compression is set according to the default
operation of the TCP port numbers in Table 26-3.
If the default operation is WAN acceleration processing, compression is set.
If the default operation is pass-through, non-compression is set.
The
compress-port
command changes this setting.
Input mode
SP configuration mode
Syntax
compress-port { on | off } {
<DPORT>
|
<DPORT>
-
<DPORT>
} [...]
compress-port { on | off } default
Parameters
{ on | off }
Specifies compression or non-compression.
1. Default value
This parameter cannot be omitted.
2. Specifiable value range
on
Specifies compression operation.
off
Specifies non-compression operation.
{
<DPORT>
|
<DPORT>
-
<DPORT>
} [...]
Specifies DPORT of the TCP L4 port number that performs
on
or
off
operation.
1. Default value
This parameter cannot be omitted.
2. Specifiable value range
0-65535
3. Maximum number of values that can be set.
16
default
Discards what has been set by specifying
on
or
off
, and resets to the default value.
(Compression is set to the TCP port numbers with the default operation WAN
acceleration processing, and non-compression is set to the TCP port numbers with
the default operation pass-through in Table 26-3.)
Содержание GX1000-SMC013X
