Hettich HettCube 200, Руководство по эксплуатации

Страница: 106 / 174

en 12.2020 / Rev. 02 AB66005 106 / 174
Operation
Fig. 166: Door
1 Acoustical warning
2 Door alarm
Fig. 167: ‘Screen’ menu
1 Brightness
2 Sleep mode (in standstill mode
only)
3
[Activate/deactivate screen lock]
switch (screen lock only possible in
combination with sleep mode)
Screen brightness
6.13.9 Door
If the door is opened, an information banner immediately appears
indicating the duration the door is opened. The duration of the door
being opened is updated in real time. The incubator calls attention to
the fact that the temperature is changing in the incubator due to the
open door; toward the ambient temperature.
You can switch the acoustical alarm on/off via the
[Acoustical
warning] button.
It can be set after what time a "Door open" warning changes to a
door alarm with the door alarm setting (Alarm delay). The triggering of
the door alarm can be set between 1 minute and 9 minutes. The set-
ting ex works is 2 minutes. The door alarm is indicated to you opti-
cally and acoustically.
6.13.10 Screen
In this menu, you can make settings on the screen.
Under the screen setting, the following can be set/activated:
■
the screen brightness can be adjusted in 6 levels;
■
the time up to the activation of sleep mode (make screen darker)
can be set;
■
the screen lock can be activated. If the lock is activated, first the
‘Admin PIN’ must be input to exit sleep mode. The ‘Admin PIN’
must also be entered to activate the screen lock.
The screen lock makes it possible to protect the incubator from
unauthorized startup. For this, the screen lock must be activated
together with sleep mode. (Sleep mode can only be active if the
incubator is in standstill mode.)
To adjust the screen brightness, proceed as follows:
Push the controller to the desired value in stages to set the
screen brightness.