Hettich HettCube 200, Руководство по эксплуатации

Страница: 76 / 174

en 12.2020 / Rev. 02 AB66005 76 / 174
Operation
Fig. 107: ‘Program segment settings

Duration

Input duration’
1 Duration in ‘days’
2 Duration in ‘hours’
3 Duration in ‘minutes’
4 [Cancel] button
5 [Clear input] button
6 [Confirmation] button
7 Keypad
7.
Fig. 108: ‘Program segment settings

Set temperature’
1 Temperature
Fig. 109: ‘Program segment settings

Input temperature setpoint’
1
[Clear input] button
2
[Confirmation] button
3 Keypad
9.
You can now either
■
select the existing values by tapping them and entering new
values via the keypad or
■
delete the existing values with the [Delete entry] button and
entering new values via the keypad.
Enter the value in days, hours and minutes. Confirm the entries
with the
[Confirmation] button.

You will go back to the
‘Program segment settings’ menu.
8. Set the temperature of the program segment. You can change
the temperature in steps of 0.1 with the
[Plus] and [Minus] but-
tons. When the temperature is tapped, the dialogue opens for
direct temperature input.
NOTICE
When entering the target temperature, also
check the temperature guard settings

Chapter 6.13.5 ‘Temperature guard’
on page 98. Only once the program starts is it
checked whether there is a contradiction
between a target temperature defined in the
program and the setting of the temperature
guard. If this is the case, a warning message is
output. No check is performed when entering
the temperature setpoint.
You can now either
■
select the existing value by tapping it and entering a new
value via the keypad or
■
delete the existing value with the
[Delete entry] button and
entering a new value via the keypad.
Confirm the entries with the
[Confirmation] button.

You will go back to the ‘Program segment settings’ menu.