Hettich HettCube 200, Руководство по эксплуатации

Страница: 28 / 174

en 12.2020 / Rev. 02 AB66005 28 / 174
Commissioning
2
1
Fig. 15: Front wooden beam
1 Fastening screws
2 Front wooden beam
1
2
3
Fig. 16: Fastening metal rails
1 Metal rails
2 Nails
3 Wooden pallet
1
2
Fig. 17: Wooden beam under the metal
rails
1 Metal rails
2 Front wooden beam
1
1
Fig. 18: Screwing in levelling elements
1 Device feet
1. Remove the two fastening screws and remove the front
wooden beam.
In the case of devices with the optional glass
door, there are additional reinforcements
attached to the wooden beam. These can be
removed with the beam.
2. Fasten the two metal rails to the wooden pallet with two nails
each.
3. Push the front wooden beam under the metal rails to support
these.
The angle between the metal rails and the floor
must not be more than 6°.
4. Screw the front levelling elements completely into the device
feet (upward).
NOTICE
The levelling elements have a height of 60 mm
when screwed-in. Hereby, the inner part proj-
ects 3 mm with respect to the outer part.
The rear levelling elements are already screwed
in ex works.