83
Default level
2: System level
Parameters
None
Description
Use the
link-aggregation lacp traffic-redirect-notification enable
command to enable link-aggregation
traffic redirection.
Use the
undo link-aggregation lacp traffic-redirect-notification enable
command to disable
link-aggregation traffic redirection.
By default, link-aggregation traffic redirection is disabled.
Link-aggregation traffic redirection applies to dynamic link aggregation groups only.
To prevent traffic interruption, enable link-aggregation traffic redirection on devices at both ends of the
aggregate link.
H3C recommends that you do not enable both MSTP and link-aggregation traffic redirection. If they are
both enabled, light packet loss may occur when a card or device reboots.
In an IRF virtual device that adopts the ring connection, slight packet loss can occur when the IRF member
device enabled with link-aggregation traffic redirection reboots. To prevent packet loss, you can enable
local-first load-sharing for link aggregation on all IRF member devices.
Related commands:
link-aggregation load-sharing mode local-first
.
Examples
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable
link-aggregation load-sharing mode
Syntax
System view:
link-aggregation load-sharing mode
{
destination-ip
|
destination-mac
|
destination-port
|
ingress-port
|
source-ip
|
source-mac
|
source-port
} *
undo link-aggregation load-sharing mode
Layer 2 aggregate interface view:
link-aggregation load-sharing mode
{
destination-ip
|
destination-mac
|
source-ip
|
source-mac
} *
undo link-aggregation load-sharing mode
View
System view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
destination-ip
: Performs load sharing in link aggregation groups based on destination IP address.
