
-76-
Model G0841 (Mfd. Since 06/18)
To adjust lower pressure rollers height:
1. Set headstock height to at least 4".
2. DISCONNECT AND LOCK-OUT MACHINE
AT POWER SOURCE!
3. Open chain drive access door.
Adjusting Lower Pressure Rollers
For best thickness planing results, set the lower
pressure rollers 0.004–0.008" above the planer
table surface, as shown in
Figure 125.
0.004–0.008"
Planer Table Surface
Lower
Pressure
Rollers
0.004–
0.008"
Figure 125. Correct lower pressure rollers
height.
Item(s) Needed:
Qty
Block Guage (Supplied w/Machine) .................. 1
Wrench Open-Ends or Socket 17mm ................ 2
adjusting lower pressure rollers
Figure 126. Block gauge placed over front lower
pressure roller.
Figure 127. Block gauge—side A.
4. Place block gauge on planer table across
one side of front lower pressure roller (see
Figure 126).
Note: Make sure side A of block gauge is
face down and notch (see
Figure 127) is
centered over top of lower pressure roller.
5. Slowly rock lower pressure roller back and
forth.
— If block gauge does lay flat across planer
table and does move when pressure roller
is rocked back and forth height, then
no height adjustment is needed. Skip to
Step 8.
— If block gauge does not lay flat across
planer table or does not move when pres-
sure roller is rocked back and forth, then
adjust height of lower pressure roller.
Proceed to
Step 6.
Planer
Table
Top of Front Lower
Pressure Roller
Block Gauge
Block Gauge
Notch
Содержание G0841
Страница 84: ......