
-66-
Model G0841 (Mfd. Since 06/18)
Planer
Table
Infeed
Table
Block Gauge
Figure 103. Infeed table even with planer table.
Calibrating Lower
Cutterhead Depth of
Cut
The lower cutterhead depth-of-cut scale can be
calibrated or "zeroed" to make sure the cutting
depth shown on the scale matches the actual cut-
ting depth (per pass).
To calibrate infeed table depth-of-cut:
1. DISCONNECT AND LOCK-OUT MACHINE
AT POWER SOURCE!
2. Align lower cutterhead. (Refer to Aligning
Lower Cutterhead on Page 64.)
3. Place block gauge across infeed and planer
tables, as shown in
Figure 103.
Note: Make sure side B of block gauge is
face down.
Item(s) Needed:
Qty
Hex Wrench 5mm .............................................. 1
Block Guage (Supplied w/Machine) .................. 1
5. Loosen cap screws that secure scale
pointer to base (see
Figure 104), precisely
adjust scale pointer to "0", and then re-tighten
caps screws.
lower cutterhead depth-of-cut
Figure 104. Adjusting scale pointer to "0".
4. Use infeed table handwheel to adjust infeed
table even with planer table, as shown in
Figure 103. Make sure there are no gaps
between infeed table and block gauge and
planer table and block gauge.
To reduce risk of shock or
accidental startup, always
disconnect and lock-out
machine from power before
adjustments, maintenance,
or service.
Depth of Cut
Set to "0"
Cap
Screws
Scale
Pointer
Depth-of-Cut
Scale
Содержание G0841
Страница 84: ......