Givi Misure VISION 700, Инструкция по эксплуатации

Страница: 6 / 72

10/06/2008 M042.E GQ
• 6 ¥ 72
INSTALLATION
W A R N I N G !
Do not switch on the instrument unless the machine conforms 98/37/EC
regulations.
The installation of the instrument must be carried out by authorised skilled
staff who will follow the regulations stated by the Manufacturer.
EARTHING The instrument is connected to earth by means of the power supply
connector. In order to avoid discharges it is advisable to use an
earthed socket. If the instrument is not connected or is improperly
connected to earth, all the accessible parts, including those which
may appear to be protected, may generate electrical discharges.
Under no circumstances is it possible to access the inside of the
instrument when it is powered from the mains power supply or by
other power-supply devices.
PROTECTION According to power supply
:
q
230 Vac - 50/60 Hz or 110 Vac 60 Hz by fuse located on the
rear panel (use only delayed-action fuses,
φ
5 x 20 mm, 500
mA 250 V).
q
24 Vac 50/60 Hz by an automatic brake circuit (self-
restoring), in case of overcurrent, short circuit and so on.
PREVENTION In order to avoid the possibility of fires or explosions, this
instrument may not be used in the presence of inflammable gases,
solvents, explosives, etc.
REAR This may be removed exclusively by specialised personnel, and in
PANEL any case after disconnecting the instrument from the mains power
supply (it is not sufficient to place the switch in the OFF position).
INSTALLATION Install the measuring scales (or rotary encoders) in accordance
with the Manufacturer’s instructions. Connect the Axis connectors
to the corresponding inputs (X,Y and Z) on the instrument. Connect
the power supply cable and then switch on the instrument (key-type
switch on the rear).
IMPORTANT NOTE:
The instrument is protected against incorrect
information caused by uncertain situations (due, for example, to sudden or
momentary mains voltage drops). In these cases, in order to inform the operator
that an accidental upset of this type has occurred, when the instrument is switched
on again, it prompts the operator to find the scale zero (rEF).