Givi Misure VISION 700, Инструкция по эксплуатации

Страница: 13 / 72

10/06/2008 M042.E GQ
• 13 ¥ 72
RETENTION OF DATA AND PROGRAMS
Program setting of
VISION is carried out beforehand by the Manufacturer, who is aware
of the access codes and of the procedures (configuration). The user can then enter the
settings required for using it. All the information is permanently stored, and can only be
changed voluntarily, by re-entering it. The instrument is also able to “remember” the last
piece of data acquired, when the power supply is switched off.
In addition to the information referred to above, the following will
also be retained:
A) The selected unit of measurement (MM/INCH).
B) Confirmed function settings, with the exception of the scale
factor and variable resolution.
C) The last Axis counting position, and any messages (not of the
transient type) indicating abnormal situations, such as :
_ _ _ _ _ _ _ _
To clear all the “operational” settings entered (resetting of counters, origins of the Axes,
tool offsets, etc.) see function “F0”
IMPORTANT Either the instrument is in the ABS or the INC mode, it is unable to
consider any shifting of the Carriages (due to inertia, manual
repositioning or thermal expansion) when there is no power supply. If
this occurs, the measurements indicated on the display will no longer
be reliable, since they will be unable to show the new position of the
Carriages but only the one before the instrument switched off.
In order to avoid errors, which may be even considerable, the operator
must consider the opportunity of relating the ABS/INC counting mode
to the scale zero reference (rEF). He will link to rEF all those functions
which he intends to use and which require this condition, as specified in
the descriptions related to the single functions (it is recommended that
these descriptions are carefully read).