GILES FSH-4 Hood, Руководство по эксплуатации и обслуживанию

Страница: 48 / 68

38
Model: FSH-4 Hood Operation & Filter Maintenance
Typically, the pre-filters should be replaced weekly (see Sections 4.02.4 & 4.02.5 ) . They CANNOT be cleaned and
are not intended for long-term use.
Use GILES replacement Item No. 91707. Write the replacement date on the new filter.
4.03.4 Pre-Filter Maintenance
Pre-Filters are single-use, disposable filters. NEVER attempt to clean and reuse; doing so
can cause damage to the unit.
IMPORTANT: Failure to use Giles OEM parts and OEM replacement filters may void the factory warranty.
The factory-recommended product to use for cleaning the E.A.C. cell in this manner is Simple Green® Pro-HD. It is
a readily available, biodegradable, non-toxic degreasing cleaner that is safe for use on aluminum. It performs well
to clean the cell when diluted at a 1:12 ratio (e.g. 1/2 gal. cleaner to 6 gals ambient water) .
DO NOT use DISHWASHING DETERGENTS or CORROSIVE CLEANERS as they can contain ingredients that may
damage the metal cell components, causing failure or unsatisfactory performance. Such damages are not
covered by the factory warranty.
1. Cleaning with this method requires a suitable, leakproof container, such as a tall trash bin, recycle bin,
plastic tote, etc. that is large enough to hold the cell along with enough degreasing solution to
completely cover and soak it, either standing on end, on edge, or lying flat.
2. Fill the container with fresh water to a level that will cover the cell. Measure water as
filling and note the quantity. Add Simple Green® Pro-HD in the ratio of 1:12 to the water
(e.g. 8 gals of water would require .67 gals (2 qts+21 ozs) degreaser . Stir solution well
to mix.
3. After preparing a quantity of degreaser solution sufficient to completely cover the cell in
the soaking container, hold cell by the contact plate , the frame, or the handle and
carefully place it into the solution. Be sure that it is fully submerged.
4. Allow cell to soak for approximately 20 minutes (no more than 30 mins) , then lift it
slightly and briefly agitate it up
&
down in the solution to help dislodge grease residue.
5. Carefully remove cell from container and follow Steps 4 thru 6 as detailed in the previous
section .
NOTE:
The degreasing solution may be used multiple times ... cover container with a lid or other suitable cover when
not in use to prevent contamination. Discard and replenish solution when a greasy film seems to remain visible,
floating on the liquid. When soaking, always ensure that solution completely covers the cell ... add some water
if needed.
B. Alternate Cleaning Method - Soaking
4.04.2 E.A.C. Filter Cell Cleaning - continued