GILES FSH-4 Hood, Руководство по эксплуатации и обслуживанию

Страница: 47 / 68

37
Model: FSH-4 Hood Operation & Filter Maintenance
4.04.2 E.A.C. Filter Cell Cleaning - continued
While handling and cleaning the cell, take care not to bend the collection fins or break the
fine ionizer wires that are stretched across the face of the cell. Bent fins and
broken/missing wires can prevent the electronic collection system from performing properly. System faults and
alarms will occur that can potentially interrupt appliance operation.
Damage from abusive handling and/or improper maintenance may not be covered by the factory warranty.
Fin
Ionizer Wire
(9) required
1. Remove collector cell from hood (see Section 4.02.6 ) and lay on a
drain board, or other suitable surface.
2. Holding the can at an appropriate distance, spray Simple
Green® Crystal Foaming Degreaser onto the E.A.C. cell,
completely covering all surfaces ... collection fins, contact
plate, brass fittings and inside corners of frame. Turn cell
over and apply to the other side in like manner, ensuring
that both sides of all collector fins are completely covered
with the foam.
3. Allow foam to soak for 5 to 10 minutes . In cases of extreme build-
up, a second application may be required after rinsing.
4. Carefully move cell to sink and rinse thoroughly, using hot water spray. Rinse ONLY, DO NOT
scrub with brushes.
5. Stand cell upright on end on a drain board, w/contact plate up ... allow it to drain and air dry
overnight. The cell must be completely dry before being replaced in hood unit. If desired, a
small electric fan can be used to blow across the cell to help expedite drying.
6. Before replacing cell in the hood, inspect for broken/missing ionizer wires and bent fins.
Broken or missing wires need to be replaced promptly. Bent fins may be straightened by
hand so that no fins are touching adjacent fins.
IMPORTANT! ONLY Simple Green® Crystal Foaming Cleaner/Degreaser is recommended by GILES for cleaning the
E.A.C. cell in this manner. Other spray cleaners can contain corrosive ingredients that may damage the metal
components of the cell, causing it to fail or not perform properly. Such damages are not covered by the factory
warranty.
A. Preferred Cleaning Method - Spray Cleaner
Continued on Next Page