Gerber ODYSSEY XP, Руководство пользователя

Страница: 69 / 84

63
Symptom Recommended Procedure
Pinch Wheel Error
Pinch wheel too far
from material edge Pinch wheels are in the wrong position. Slide grit
wheels and pinch wheels to place one pinch wheel
one-half inch from material edge.
Pinch wheels are up
Move pinch wheel lever to lower the pinch wheels.
No power Check power cable, plugs, fuses, and ON/OFF switch.
Poor cut quality Clean grit wheels.
Check knife settings (speed, force, acceleration, and
corners).
Adjust or replace knife blade.
Check plastic cutting strip located on the X axis.
Poor performance Clean grit wheels.
Perform routine cleaning and lubrication.
Check corners and force settings.
Check blade exposure.
System error code number See “Error codes” beginning on page 59.
Thick and thin strokes Check in this order:
1
Material alignment
2
Blade exposure
3
The blade should swivel freely and not wobble in
the knife tool.
Tool is missing
Verify that the tool is properly loaded.
You can choose to ignore the warning without a
problem. The warning occurs only once. After the
warning, the plotter waits for you to start the job,
cancel the job, or insert a tool
Tool latch binds Apply a light coating of grease on the male part of the
door latch mechanism.
Wide material:
DROP pressure lever
on middle pinch wheel
Incorrect pressure on middle pinch wheel.
Lower the pinch wheel pressure lever.