Gerber ODYSSEY XP, Руководство пользователя

Страница: 18 / 84

12 CHAPTER 2
Getting Started
5 If an error is detected, the display shows
Reload Material. Sensors
indicate improper loading
.
To check and reload material
1
Make sure the material roll stops are in the correct position and that
the roll hasn’t “walked” during the material alignment sequence.
2
Remove and reload the material.
3
Make sure the material runs under both the front and rear edge
sensors.
4
Make sure the grit wheels, pinch wheels, and pinch wheel lever are in
the correct position.
5
If the right edge of the material is damaged, or if the sheet is small
(typically shorter than 25" (64 cm)), select No for
Auto Align Material?
and turn skew control off as described later in this section.
Cutting clear material
Clear (transparent) material (such as Clear Enamel Receptive, or any
material with a clear edge) is not detected by the optical edge sensors.
Auto alignment, skew, and material out indications are not in effect
because the material is invisible to the optical edge sensors. When using
clear material, the following special instructions apply.
To use clear material
1
Load and manually align the material to make sure it is straight.
2
Pull the pinch wheel lever forward. The message No Material Found
appears.
3
Press F4 (Ignore).
4
Press F3 (Search) to locate the pinch wheels.
5
Run the job.
Note: Not all “clear” materials go undetected at first. If you are having
difficulty with a material you believe to be “clear,” turn off skew control as
described in the next paragraph.
Turning off skew control
Skew control maintains material edge alignment during operation. The
two material edge sensors monitor material edge movement to eliminate