GE Healthcare
Senographe DS Acquisition System
Revision 1
Operator Manual 5307907-3-S-1EN
Printing
13-print.fm
Page no. 139
Chapter 13
2
Printer management
Printers are set up and declared to the system at the time of installation by the GE Field Engineer; printer
information cannot be changed by the user.
The access to this function is from the Tools menu
3
Print functions
3-1
Auto Print
Auto Print is a function allowing the user to automatically initiate the printing of exam images on closure
of the exam from the AWS.
Images with a Quality Check value of
OK
are automatically printed by the Auto Print function.
If RRA is installed and enabled, the printing of images with a Quality Check value of
NOT OK
depends
on Quality Check settings in Medical Application preferences (see Chapter
cal Application preferences on page 75
, subheading
).
If RRA is not installed or disabled, images with a Quality Check value of
NOT OK
are not automatically
printed at the close of the exam.
To use Auto Print, open the
Tools
menu from the Browser (see Chapter
), and select
Medical
Application preferences
. Click on
Auto Print
in the Medical Application preferences window to access
the Auto Print setup tool.
Facilities available from the Auto Print window are:
•
DICOM printers
: contains the list of all the available DICOM printers that have been declared for
printing. Click on a printer in the list to select it.
•
Review Rooms
: contains the list of all environmental conditions of available review rooms. Select the
room corresponding to the printer. Refer to your field engineer or printer manufacturer for review
room configuration.
•
Auto Print buttons
: click the
On
button to turn Auto Print on for the selected printer or the
Off
button
to turn it off. The selected button becomes dark gray.
•
Save button
: click this button to confirm any changes made and close the window.
•
Close button
: click this button to close the Medical Application preferences window. If the user has
made changes to the
Auto Print
window, a Warning window opens requesting the user to use one of
the following:
-
Save
button (to save the changes and return to the Browser).
-
Cancel
button (to cancel changes made, close the Warning window and return to the
Auto Print
window).
-
Discard
button (to close without saving the changes and return to the Browser).
•
Print mode
: only
Fit to Film
. Can not be changed by the user in current Senographe DS release.
•
Number of Copies box
: enter the required number of copies in this box.
•
Printer properties button
: click this button to open the
Printer properties
window
3-3 Printer properties on page 141
).
FOR
TRAINING
PURPOSES
ONLY!
NOTE:
Once
downloaded,
this
document
is
UNCONTROLLED,
and
therefore
may
not
be
the
latest
revision.
Always
confirm
revision
status
against
a
validated
source
(ie
CDL).
