GE Senographe DS, Руководство оператора

Страница: 113 / 210

GE Healthcare Senographe DS Acquisition System
Revision 1 Operator Manual 5307907-3-S-1EN
Viewer
11-viewer.fm
Page no. 113 Chapter 11
- In this panel, select the correct laterality (R in the present example) and the view name.
The list of laterality/view name available depends on position of the gantry; see section
4-1 .View
names on page 39 in Chapter 4 X-ray Console for the complete list in all positioner configura-
tions.
Note:
The view prefix cannot be modified: if a Mag Stand was present for the image acquired, the prefix
("M") is automatically kept for the view name.
CAUTION
The view suffix can be modified as desired unless the acquisition has been done with a
spot compression paddle (with or without magnification). In that case, select only a view
name with suffix "S". On the other hand, if the acquisition was NOT done with a spot com-
pression paddle, DO NOT select a new view name with the suffix "S". If these directions
are not followed, there is a risk of inconsistency with the processing applied.
• At this point, you can either Cancel or Save the selection.
-
If you click Cancel , the laterality for the raw, processed, and all reprocessed images from this
raw, remains as previously selected (i.e. "L" in the present example).
- If you click Save , the new laterality applies for the raw, processed and all reprocessed images
from this raw (i.e. "R" in the present example).
New view name list after laterality selection = R
for an image initially acquired with laterality = L and positioner angle = -35°
view name with suffix "S"
laterality view name
Save
Cancel
laterality and view name selection
FOR
TRAINING
PURPOSES
ONLY!
NOTE:
Once
downloaded,
this
document
is
UNCONTROLLED,
and
therefore
may
not
be
the
latest
revision.
Always
confirm
revision
status
against
a
validated
source
(ie
CDL).