Gap Diagnostic IIDTool Pro, Руководство пользователя

Страница: 49 / 194

48 49
IIDT
ool
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
2.8.2 Connecting the IIDTool
Once the OBDII connector is located, the unit can now be connected.
Connection steps
1- Ensure compliance with safety instructions and tips to avoid battery drainage (
section 2.7
)
2- Switch on the ignition or start the engine if outside respecting the safety instructions (
section
2.7.1
)
3- Locate the OBDII connector (previous section)
4- Insert the IIDTool into the OBDII connector
5- Wait for about 30 seconds while the tool is scanning electronic communication buses. *
- II The message “ IIDTool Ready ” will appear on the vehicle instrument pack display to indicate
that communication has been successfully established.
-If it turns out that communication with one of the buses is not possible, an error message
will appear on the selected interface** and the current process will be interrupted. See the
Frequently Asked Questions (FAQ) section on the manufacturer’s website for a solution to this
problem:
https://www.gap-diagnostic.com/
.
6- Launch the IIDTool Interface of choice and navigate as described in the next segment.
* Pro This waiting time is only present upon first connection of the tool on a new vehicle and following
an update of the firmware of IIDTool. BT and regular. This waiting time is present when connecting to
a vehicle on which the tool is unlocked or following an update.
** II In some cases, a communication problem on one of the buses will prevent the tool from writing to
the instrument cluster.